This topic and its replies were posted before the current version of LEADTOOLS was released and may no longer be applicable.
#1
Posted
:
Thursday, August 9, 2007 3:06:21 AM(UTC)
Groups: Registered
Posts: 3
Hi,
i would like configure my scanner from my UI, that s it s possible but i can t use all the capabilities of my scanner; i have this message" the capability is not supported ".
i developp with c# and leadtools 14.5
Best regards
#2
Posted
:
Thursday, August 9, 2007 7:20:21 AM(UTC)
Groups: Registered
Posts: 3
I tested the demo version 15, it s a same.
#3
Posted
:
Sunday, August 12, 2007 8:43:31 AM(UTC)
Groups: Manager, Tech Support
Posts: 367
Was thanked: 1 time(s) in 1 post(s)
Zouhair,
Does your scanner's Twain driver support the capability that gives you this error? If want to check, you can use a utility from the TWAIN working group called Twacker. You can set and get capabilities for scanners using this program, in addition to perform scanning. Please try it if you haven't done so already to make sure the problem is not in the driver. If you don't have it, you can get it from:
http://www.twain.org/devfiles/twack.zip
Use it to set and get the same capabilities and values that fail with LEADTOOLS.
Amin Dodin
Senior Support Engineer
LEAD Technologies, Inc.
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.