Offset in raster image viewer

I want to copy the image from a medical viewer cell to a raster image viewer. I can do all that with the clone method and can even handle any scaling performed on the medical viewer cell BUT I cant figure out how to apply the offset from the medical viewer cell to the raster image viewer

What im trying to do is lay a raster image viewer on top of a medical viewer cell so that it looks the same as before.

thisScale = cell.GetScale(0);
int thisScaleI = Convert.ToInt32(thisScale);

MedicalViewer myViewer = cell.ParentViewer;
int cellIndex = cell.Index;
MedicalViewerOffset thisOffset = (MedicalViewerOffset)myViewer .GetActionProperties(MedicalViewerActionType.Offset, cellIndex);

//SET SCALING TO BE THE SAME AS IN MEDICAL VIEWER CELL
imageWidth = Convert.ToInt32((cell.Image.Width * 100) / thisScaleI);
imageHeight = Convert.ToInt32((cell.Image.Height * 100) / thisScaleI);


locationX = Convert.ToInt32((cell.Image.Width - imageWidth) / 2);
locationY = Convert.ToInt32((cell.Image.Height - imageWidth) / 2);

// Copy the medical viewer cell image into the raster viewer
Rectangle rect = new Rectangle(locationX, locationY, imageWidth, imageHeight);
m_rasterViewer.Image = cell.Image.Clone(rect);

?????? Where do i apply the offset so that the image is in the same position on the raster image viewer as the Medical viewer cell????????

I'm using Leadtools 15 and .NET

thanks

I'm not sure what you're trying to accomplish is going to be possilbe with the raster
image viewer, but I'd like to try to better understand what you're trying to accomplish.

You stated that you're trying to lay a raster image viewer over the medical viwer. Are
you trying to mimic the medical viewer with the raster viewer? What is your reason behind
doing this?

I need a better idea of the big picture in order to assist you.

Hey Walter

I need to mimic the medical viewer with the raster viewer so as to get access to the annotation container in the raster image viewer, I will then add some annotations (where by I need to adjust thier properties like precision, colour etc etc as I draw them) to the raster image viewer and save them to a .Ann file.

I will then load these annotations to the medical viewer cell so that it looks like the work was carried out on the medical viewer itself.

In short I'm trying to implement a work around for the fact that I cant get access to the medical viewer cell's annotation container. Its almost working too except for this offset business!

thanks

The RasterImageViewer doesn't have the concept of offsets like the MedicalViewer. You'll need to manually paint to a Graphics object on the form using the RasterImage.Paint method.

You'll also want to check out a posted MedicalViewer demo that uses annotations. You can find it here: http://support.leadtools...rums/20832/ShowPost.aspx

Note: The RasterImageViewer isn't necessary for modifying the annotations as shown in the demo. Any changes in the properties should be able to be done behind the scenes without a viewer.