Saving out a muti-page tiff.

I am using LeadTools to read in a (1bit pp) multi-page CCITT Group 3 faximage and then write
out to a CCITT Group 4 fax image. I can open the file and save it but only the 1st page is saved
in CCITT Group 4 fax image. I believe that I need to somehow iterate through each frame and save
each one back out. My problem is how do I tell it which frame to save?
TheRetVal=LT.Load("c:\\mytiff_G3.tif",0,0,1);
TheRetVal=LT.Save("c:\\mytiff_G4.tif",29,1,2,0);

Edited by moderator Thursday, October 20, 2016 10:41:08 AM(UTC)  | Reason: Removed defunct emoticon

To determine which page to save, set BitmapListIndex to the index of
the desired page, then call Save.  The index is zero-based. 
To save all pages to a single file, you should iterate through all
pages and pass SAVE_APPEND to the last parameter of Save.  The code should  look something like this:

For i = 0 to LT.BitmapListCount - 1
    LT.BitmapListImdex = i
    LT.Save filename, FILE_TIF, 1, 2, SAVE_APPEND
Next i

Thanks for your reply...
When I go and run your save it create a CCITT GROUP 4 TIF file but with only 1 page? (the source file is 2 pages)
When I trace the 1st save for the 1st page it works... The 2nd save for the 2nd page returns
a 20002 or ERROR_NO_BITMAP.  I checked the source file and it does infact have 2 pages.
Also LT.BitMapListCount says 1 which I assume means two pages right?

Here is my code...

TheRetVal=LT.Load(SourceFILE,0,0,1);
TheRetVal=LT.Size(Width, Height, 0);
LT.BitmapXRes = 204;
LT.BitmapYRes = 196;
LT.ForceRepaint();

for(int ii=0; ii<=LT.BitmapListCount; ii++)
{
   LT.BitmapListIndex = (short)ii;
   TheRetVal=LT.Save(TempTargetFile, 29, 1, 2, 1); //FILE_CCITT_GROUP4=29 FILE_CCITT_GROUP3_1DIM SAVE_APPEND=1
}

Thanks very much   Paul

Please note the following:
1. BitmapListCount contains the number of bitmaps. A value of 1 means only one page, not 2.
2. This means BitmapListIndex varies from 0 to (BitmapListCount-1).

3. To load multiple pages of a file at once into the BitmapList, pass
the number of pages in the last parameter of the Load method (lPages). To load all pages, pass -1 (minus one).


The cause of error code you got was assigning 1 to BitmapListIndex and
trying to save. Your list had only 1 image, which means the BitmapListIndex can only be 0.

Amin Dodin
LEADTOOLS Technical Support