ILMAFlanger Interface

Data types:

FLANGER_ATTRIBUTES

typedef struct 
{ 
   long lDryMix; 
   long lWetMix; 
   long lDelay; 
   long lFeedback; 
   long lRate; 
   long lSweep; 
   long lStereo; 
   BOOL bEnabled; 
   long lDDryMix; 
   long lDWetMix; 
   long lDDelay; 
   long lDFeedback; 
   long lDRate; 
   long lDSweep; 
   long lDStereo; 
   BOOL bDEnabled; 
} FLANGER_ATTRIBUTES;

Describes the flanger attributes.

Member	Description
lDryMix	Controls the level of unprocessed signals. Adjust to control the pass-through volume of the unprocessed signal.
lWetMix	Controls the level of processed signals. Adjust to control the pass-through volume of the processed signal.
lDelay	Controls the level of flange effect. :Larger values result in greater delay times.
lFeedback	Feedback of the repeated signal, by default from -100 to 100. Zero feedback will result in only a single repeat, while nonzero feedback settings will generate numerous repeats.
lRate	This parameter refers to the rate at which the LFO waveform repeats itself. By increasing the speed, the flanger will have to sweep through the depth in less time.
lSweep	The sweep depth determines how wide the sweep is in terms of delay time - essentially the width of the LFO. This sweep depth is the maximum additional delay that is added to the signal in addition to the delay in the delay parameter.
lStereo	Stereo represents the phase difference between the left and right channel.
bEnabled	Indicates whether the Flange effect is enabled (TRUE) or not (FALSE).
lDDryMix	Default Dry Mix value. Original default value is 70.
lDWetMix	Default Wet Mix value. Original default value is 50.
lDDelay	Default delay value. Original default value is 500.
lDFeedback	Default feedback value Original default value is 25.
lDRate	Default rate value Original default value is 5.
lDSweep	Default sweep value Original default value is 10.
lDStereo	Default stereo value Original default value is 90.
bDEnabled	Default for bEnabled value Original default value is TRUE.